The following diagrams illustrate the measurements we will need from you when ordering thru-hull exhaust components such as diverters or complete muffler systems. To make ordering easier, fill out the form at the bottom of this page click the button below. We will be asking for your Boat Year, Make and Model, Engine Size, (Mercury, Volvo, OMC), Drive Model, And is it an EFI or Carbureted Engine.

Under Swim Platform Applications

For boats with built in or bolt-on swim platforms that are not equipped with thru-hull exhaust, the following measurements will determine if there is enough space under the swim platform to install a standard system or if a custom system will be required.

Measurement A - Distance measured from the top of the drive (gimbal) housing to the underside of the swim platform.

Measurement B - Distance measured from the vertical center line of the drive (gimbal) housing to the upper corner of the drive cavity. For bolt-on swim platforms, measure the distance to the first mounting bracket.

NOTE: When measuring distances on a built in swim platform, measure to the tangent of the radius as shown in the illustration to the right. Also applies to Twin Engine applications.

Location of Existing Exhaust Holes

For boats that are equipped with thru-hull exhaust, the following measurements will determine if the exhaust holes are in the standard location for your particular motor or if a custom system will be needed to meet the existing exhaust holes.

Measurement X - Distance measured from the top of the drive (gimbal) housing to the horizontal center line of the exhaust hole.

Measurement Y -  Distance measured from the vertical center line of the drive (gimbal) housing to the vertical center line of the exhaust hole. Also applies to Twin Engine applications.